Users Manual

PRODUCT INFORMATION
Pull-force measurement system
1 SAFETY NOTES
Always consider the following points:
Follow the operating instructions
Avoid impacts and vibrations to the system
The system may be operated only within the specified technical values and limits.
Commissioning, adjustments and operation is allowed only by qualified personnel.
In the cases of improper system adjustment or use, the OTT-JAKOB company will not
accept any liability.
1.1 INTENDED USE
The pull-force measurement system has been designed for an industrial environment. The pull-
force measurement system POWER-CHECK measures the pull-force in power drawbars.
The pull-force measurement system is embedded in the tool holder. The force occurring after the
clamping process is detected by the measurement system.
It is possible to use the measuring device in a tool magazine.
The measuring device sends the measuring value to the receiving device.
1.2 BATTERY
The POWER-CHECK contains a solid-state, non-replaceable Li/SOCl2 battery. The battery
must be replaced only by the equipment manufacturer. Always consider the following points:
do not charge
do not short-circuit
do not throw in fire
do not damage
do not bring it in contact with water
pay attention to the temperature range
do not dispose in household waste
UL registration number of the battery: MH-12827
The battery contains 0,65 g lithium. Therefore, the battery is neither subject to the hazardous materials
regulations.
95100422PE_2020-09-22
Subject to modification due to technical advance! // 5