User's Manual
CHAPTER2
Installingtheremotewirelessmodem
14
PIN required: yes
PIN accepted: yes
PIN count: 3
PUK required: no
GSM network: registered
Operator: T-Mobile Austria
Signal quality: 31 99
Phone call: no
GPRS network: registered
IP address: no
TCP connection: no
0
#
The above system output shows that:
• The GSM/GPRS modem is present and activated.
• A valid SIM card is inserted.
• The SIM card was activated with the valid PIN code.
Note: The user can enter the PIN code a maximum of three times. Because
the PIN count in the example shows three entries left, the PIN code
was correctly entered on the first try.
• A GSM network was detected with the operator name T-Mobile
Austria.
• The signal quality range is between 1 and 31, where 31 is the
best possible cellular coverage.
Note: The parameters GPRS network, IP address, and TCP connection
change after the GPRS settings are entered.
To enable the data connection between the A850 and the RA440,
certain steps must be executed. These steps are split into three
sections:
1. Configuring the GPRS parameters
2. Configuring the TCP parameters
3. Configuring the A850-RA440 Connection settings
ConfiguringtheGPRSparameters
Prepare the GPRS parameters provided by your cellular network
provider to enable proper GPRS operation of the RA440. Following are
the GPRS configuration settings:
GPRSAPNSERV "[servername]"
where [servername] is the name of the network
provider's GPRS access server (required)