User's Manual

Table Of Contents
CHAPTER 3
Using terminal commands
33
REMOTE Yes, via XCONF only.
EXAMPLE LVA 0x18
38193 LVA 0
#
LVA
38193 LVA 24 0
#
COMMAND DPE
DESCRIPTION Enables storing digital pin states on changes. If this mode is
enabled, the digital pin states are sampled every second and
stored if either the pin state changed or the specified maximum
timeout (in seconds) is over.
Note: this event-dependent data is stored in special sensor values
that do *NOT* correspond with the standard sensor values for dig-
ital pins. If you need both type of data, you must connect two dif-
ferent sensors on the A840/A850 gateway.
PARAMETERS Channel
bitmask
and
timeout
(in seconds, max. 65535). If
timeout
is nonzero, the pin state is stored after
timeout
, regardless of the
pin has changed or not. If timeout is zero, the pin state is stored on
changes only.
The format of the bitmask is:
bit 0: 1=enable DPE for channel 0
bit 1: 1=enable DPE for channel 1
bit 2: 1=enable DPE for channel 2
RETURNS The current setting.
REMARKS GET/SET.
REMOTE Yes, via XCONF only.
EXAMPLE DPE 0x03 60
38193 DPE 0
#