Installation Instructions

ManualsBrandsOtodata Wireless Network ManualsElectronicsBLE Tracker

Label on Device

ISED Non-interference Disclaimer

This device contains licence-exempt transmitter(s)/

receiver(s) that comply with Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

1. This device may not cause interference

2. This device must accept any interference, including

interference that may cause undesired operation of

the device.

L’émetteur/récepteur exempt de licence contenu dans

le présent appareil est conforme aux CNR d’Innovation,

Sciences et Développement économique Canada

applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions

suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

RF Exposure Statement for ISED

This equipment complies with ISED RSS-102 radiation

exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with

minimum distance 20 cm (7.6 inches) between the radiator

and any part of your body. This transmitter must not be co-

located or operating in conjunction with any other antenna

or transmitter.

Our se conformer aux exigences de conformité ISED

RSS-102 RF exposition, une distance de séparation d'au

moins 20 cm doit être maintenue entre l'antenne de

cet appareil et toutes les personnes. Lanceurs ou ne

peuvent pas coexister cette antenne ou capteurs avec

d'autres.

RF Exposure Statement for FCC

This equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment. This transmitter

must not be co-located or operating in conjunction with

any other antenna or transmitter. In order to avoid the

possibility of exceeding the FCC radio frequency exposure

limits, this equipment should be installed and operated

with minimum distance 20 cm (7.8 inches) between the

antenna and your body during normal operation. Users must

follow the speciﬁc operating instructions for satisfying RF

exposure compliance.

M/N: ES3022

F/W: 1.0

IC: 12649A-BEHT3AD

FCC ID: 2ADQFBEHT3AD

FAIT AU

CANADA

Barcode

M/N: ES3026