Installation Instructions

M/N: ES3016
F/W: 1.0
IC: 12649A-BEHT3AD
FCC ID: 2ADQFBEHT3AD
FAIT AU
CANADA
Barcode
ISED non-interference disclaimer
This device contains licence-exempt transmier(s)/receiver(s) that comply with
Innovaon, Science and Economic Development Canada’s licence-exempt RSS(s).
Operaon is subject to the following two condions:
1. This device may not cause interference
2. This device must accept any interference, including interference that may cause
undesired operaon of the device.
L’émeeur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovaon, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitaon est autorisée
aux deux condions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est suscepble d’en compromere le fonconnement.
RF Exposure statement for ISED
This equipment complies with ISED RSS-102 radiaon exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20 cm (7.6 inches) between the radiator and any part of
your body. This transmier must not be co-located or operang in conjuncon
with any other antenna or transmier.
Our se conformer aux exigences de conformité ISED RSS-102 RF exposion, une
distance de séparaon d'au moins 20 cm doit être maintenue entre l'antenne de
cet appareil et toutes les personnes. Lanceurs ou ne peuvent pas
coexister cee antenne ou capteurs avec d'autres.
RF Exposure statement for FCC
This equipment complies with FCC radiaon exposure limits set forth for an
uncontrolled environment. This transmier must not be co-located or operang in
conjuncon with any other antenna or transmier. In order to avoid the
possibility of exceeding the FCC radio frequency exposure limits, this equipment
should be installed and operated with minimum distance 20 cm (7.8 inches)
between the antenna and your body during normal operaon. Users must follow
the specic operang instrucons for sasfying RF exposure compliance.
Label on Device: