Installation Guide

ManualsBrandsOticon ManualsElectronicsHearing Aid Module

PEOPLE FIRST

Oticon Radio Model - Quick Installation Guide

Radio Model Name: DRITE

The DRITE 4 radio model is a low power, inductive radio transceiver working at 3.84 MHz consisting of an RF Engine Block (incl. DSP, radio & memory),

antenna coil, motherboard (incl. small passive components) and intended to be installed as a module into Oticon wireless hearing aid devices only. The module also

has all voltage regulators included inside the engine block. The module requires a battery, one or two microphones on a flex PCB and a speaker to be attached and

must be mounted in an external plastic shell. It is possible for authorized personnel only to program the module through a flex I/O. The module is depicted below:

DRITE Radio Model (seen from the top side)

DRITE Radio Model (seen from the bottom)

RF Engine

Block

Antenna

Motherboard

Battery -

Battery +

Program flex I/O

Speaker unit connectors

Mic flex

Oticon A/S Kongebakken 9 DK-2765 Smørum www.oticon.com

Main +45 39 17 71 00 Fax +45 39 27 79 00 Denmark CVR-no. 42334219

Summary of content (3 pages)

PAGE 1
PEOPLE FIRST Oticon Radio Model - Quick Installation Guide Radio Model Name: DRITE The DRITE 4 radio model is a low power, inductive radio transceiver working at 3.84 MHz consisting of an RF Engine Block (incl. DSP, radio & memory), antenna coil, motherboard (incl. small passive components) and intended to be installed as a module into Oticon wireless hearing aid devices only. The module also has all voltage regulators included inside the engine block.
PAGE 2
PEOPLE FIRST Oticon Radio Model - Quick Installation Guide Radio Model Name: DRITE DRITE Radio Model (seen from the side) FCC ID: U28FU2DRIT Oticon A/S Main +45 39 17 71 00 IC: Kongebakken 9 Fax +45 39 27 79 00 1350B-FU2DRIT DK-2765 Smørum Denmark www.oticon.com CVR-no.
PAGE 3
PEOPLE FIRST Oticon Radio Model - Regulatory Label Information Radio Model Name: DRITE Contains: U28FU2DRIT 1350B-FU2DRIT FCC ID: IC: NOTICE: This device complies with Part 15 of the FCC Rules and with the license exempt standard RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.