User Manual

Item Part 1177
No. No. Description 1155 1156 1157 1158 1176 1181 1178 1179 1189 7947 7948
1 44148 6-1/2" Internal / External Puller Jaw 3 3 3
2 44195 4-1/8" Internal / External Puller Jaw 3
3 34698 3-3/4" Internal / External Puller Jaw 3333333
4 32054 2-3/8" Internal Puller Jaw 3 3 3
5 27241 Cross Nut 1111111
6 24544 3-Way Puller Head 1111111
7 24545 Cone 1111111
8 10384 Hex Jam Nut 3333333
9 22021 Hex Hd. Cap Screw 3333333
10 36578 Cross Block 1
11 24833 Forcing Screw 11
12 520968 Puller Head 11
13 10394 Hex Jam Nut 11
14 34331 Hammer (5 lb.) 1 1 1 1111
15 208627 Shank & T-bar Assembly 11111111111
16 22185 Hammer (2-1/2 lb.) 1 1 1 1
17 309321 Forcing Screw 11
18 215895 Sleeve 11
19 1152 Internal Pulling Attachment (see below) 1 1
20 205378 Vise Grip Adapter (single-lead thread) 1111
Note: If the grip wrench has a double-
lead thread, it will be necessary to
order a double lead adapter (218875).
21 205377 Dent Puller (contains Items 22 & 23) – –
22 205399 Retainer 1111
23 104427 Self-Tapping Screw 1111
24 31599 Pulling Adapter 1111
25 27315 Seal Hook 11111
Safety Precautions
CAUTION: To avoid injury when using this tool,
•
Wear eye protection that meets ANSI
Z87.1 and OSHA standards.
•
Cover the work with a protective
blanket or canvas to reduce danger
from breaking parts.
•
Adjusting strap bolts must be tight on puller jaws.
•
Puller legs and jaws must be in-line and the setup
must be rigid.
•
Apply force gradually. If maximum force has been
applied and the work piece has not moved, use a
puller with a larger capacity. Do NOT hit the part
with a hammer in an attempt to jar it loose.
Jaws Spread Jaws Reversed
Puller Head
Cone
Important: When using the jaws in the spread or reversed
position as shown, thread the cone as close to the puller
head as possible to ensure a firm grip on the part.
1 32137 2 4" Clearance Jaw
2 10054 2 Hex Hd. Cap Screw
(3/8-24 x 1-1/2" Lg.)
3 10386 4 Jam Nut (3/8-24)
4 24847 1 Tapped Swivel
5 24846 1 Adjusting Screw
6 11560 1 Roll Pin
7 24848 1 Plain Swivel
8 33482 1 Puller Yoke
Item
No.
Part
No.
No.
Req'd
Description
Internal Pulling Attachment (1152)
Catalog Slide Hammer Set No.
Parts List & Instructions Form No. 104820, Sheet 1 of 1, Back