User Manual

Form No. 538623
Operating Instructions
for: 6695
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: [phone]
Tech. Serv.: [phone]
Fax: [phone]
Order Entry: [phone]
Fax: [phone]
International Sales: [phone]
Fax: [phone]
© 2006 SPX Corporation, Rev. C, December 14, 2007
Ford Axle Shaft Seal Installer
Application: 1998–2004 Ford F-250, F-350, F-450, & F-550 4x4 trucks w/ vacuum-operated front axle
1. Place axle shaft seal onto axle shaft.
2. Position No. 6695 installer over seal as shown in Fig. 1, and use a hammer to seat seal onto shaft.
3. Insert axle shaft into axle housing.
4. Position No. 6695 installer over shaft as shown in Fig. 2, and use a hammer to install axle shaft seal into wheel knuckle.
No. 6695
Axle Shaft Seal
Figure 1
No. 6695
Figure 2
CAUTION: To prevent
personal injury, wear eye
protection that meets ANSI
Z87.1 and OSHA standards.