User Manual

Form No. 567768

Sheet No.

Issue Date: December 13, 2016 Rev. C

Parts List & Operating Instructions Form No. 567768

567620 Ford VCT Alignment Tool

Application: 2011 – 2014 1.6L Escape, Fusion, Transit

2013 – 2014 1.6L Fiesta

Note: If camshaft service is required, install the 567621 Ford

Camshaft Holding Timing Tool into the end of camshaft rst.

1. The timing marks on the camshaft phaser and sprocket

must be at the 12 o'clock position.

2. Install the 567620 to maintain this position.

3. Perform camshaft service as required according to vehicle

service manual.

CAUTION: Do not loosen or remove the crankshaft pulley

bolt without rst installing the 567620. The crankshaft

pulley and the crankshaft timing sprocket are not keyed

to the crankshaft. Before any repair requiring loosening

or removal of the crankshaft pulley bolt, the crankshaft,

and camshafts must be locked in place by the 567620,

otherwise engine damage may occur.

567621 Ford Camshaft Holding Timing Tool

Application: 2011 – 2014 1.6L Escape, Fusion, Transit

2013 – 2014 1.6L Fiesta

Note: Use an open-ended wrench to hold the camshafts by

the hexagon to prevent the camshafts from turning.

1. Rotate each camshaft until the 567621 ts into the end

of the camshafts.

Note: When 567621 is installed, the timing marks

of the camshaft phaser and sprocket must be at the

12 o'clock position.

2. Perform camshaft service as required according to vehicle

service manual.

14 of 15

567768_10

567620

No. 567620

567768_11

567621

No. 567621

WARNING: Wear eye

protection that meets ANSI

Z87.1 and OSHA standards.

WARNING: Wear eye

protection that meets ANSI

Z87.1 and OSHA standards.