User Manual

511537 (6470) Ford Camshaft Sensor Synchronizer Tool
511536 (6469) Ford Camshaft Sensor Synchronizer Tool
Parts List & Operating Instructions Form No. 567768, Sheet 6 of 15 back
Application: 1997 3.8L V6 Cougar, Thunderbird
1997 – 2008 4.2L V6 Econoline, F-Series Truck
1996 – 1998 5.0L V8 Ford Explorer, Mercury Mountaineer
2004 – 2007 4.2L Freestar, Monterey
1996 – 1998 3.8L V6 Mustang, Windstar
CAUTION: Before removing the camshaft sensor housing
assembly, note the position of the camshaft sensor
electrical connector. To prevent equipment damage, the
connector MUST be reassembled in the same position
during installation.
1. Rotate crankshaft to set No. 1 cylinder at top dead center of
the compression stroke.
2. Engage camshaft sensor housing vane in slot of tool No.
511536 (6469).
3. Rotate tool on camshaft sensor housing until tool engages
housing notch. (Tool should be square and in contact with
entire top of housing.)
4. Install camshaft sensor housing and tool assembly into engine
according to instructions in the vehicle service manual. Torque
fasteners to factory specifications.
Camshaft
Sensor
Housing
No. 511536
(6469)
Note: Same as Ford No. 303-562 (T96T-12200-A).
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
Application: 1999 – 2002 5.0L V8 Explorer, Mountaineer
2004 – 2007 3.9L Freestar (VIN 6)
2004 3.9L Monterey (VIN 6)
1999 – 2004 3.8L V6 Mustang
1999 – 2003 3.8L V6 Windstar
CAUTION: Before removing the camshaft sensor housing
assembly, note the position of the camshaft sensor electrical
connector. To prevent equipment damage, the connector
MUST be reassembled in the same position during installation.
1. Rotate crankshaft to set No. 1 cylinder at top dead center of
compression stroke.
2. Engage camshaft sensor housing vane in slot of tool No. 511537
(6470).
3. Rotate tool on camshaft sensor housing until tool engages
housing notch. (Tool should be square and in contact with entire
top of housing.)
4. Install camshaft sensor housing and tool assembly into engine
according to instructions in the vehicle service manual. Torque
fasteners to factory specifications.
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
Camshaft
Sensor
Housing
No. 511537
(6470)
Note: Same as Ford No. 303-630.