User Manual

Bearing Installation
NOTE: The bearing installer must be
assembled with the at side toward
the bearing and the small diameter
pilot away from the bearing.
1. Lightly lubricate the new bearing,
and position it for installation with
the tool components assembled
as shown in Figure 7 for outboard
installation or Figure 8 for inboard
installation.
2. Align all compo n ents and
tighten forcing screw nut to hold
components for a straight push.
3. Operate the pump to extend the
cylinder piston to press the bearing
into the spindle assembly until it
bottoms.
4. Install the snap ring in the knuckle.
Parts List and Operating Instructions Form No. 562717, Sheet 3 of 3, Back
Front or Rear Hub Installation
NOTE: The bearing installer must be
assembled with the at side toward
the bearing and the small diameter
pilot away from the bearing.
1. Assemble the tool components as
shown in Figure 9.
2. Align all compo n ents and
tighten forcing screw nut to hold
components for a straight push.
3. Operate the pump to extend the
cylinder piston and install the hub.
Figure 7
Figure 8
Figure 9
22301
Cylinder
314194
Adapter
523410
New Bearing
Adapter
311881
311881
Adapter
New Bearing
Adapter
523410
Cylinder
314194
22301
Cylinder
523410
Nut
22301
Forcing
Screw
314194
311881
Adapter
Adapter