User Manual

Sheet No.
Issue Date: Rev. C February 20, 2013
© 2012 Service Solutions U.S. LLC
Parts List and Operating Instructions Form No. 562717
Front or Rear Hub Removal
1. Lubricate the forcing screw from
this kit, assemble components, and
attach Hub Grappler to hub as shown
in Figure 4.
2. Align all components and tighten
forcing screw nut to hold components
for a straight pull.
3. Operate the pump to extend the
cylinder piston just far enough to
pull the the hub assembly.
Bearing Removal
1. Remove the snap ring from the
outboard (or inboard) side of the
knuckle.
2. For outboard side removal:
Assemble the tool components as
shown in Figure 5.
For inboard side removal:
Assemble the tool components as
shown in Figure 6.
3. Align all components and tighten
forcing screw nut to hold components
for a straight push.
4. Operate the pump to extend the
cylinder piston just far enough to
press out the worn bearing.
2 of 3
Figure 4
Figure 5
Figure 6
Cylinder
523410
Nut
22301
Forcing
Screw
314194
311881
311881
Adapter
Adapter
Adapter
523410
Cylinder
314194
22301
Cylinder
314194
Adapter
523410
Adapter
Adapter
311881
22301
Adapter