Specifications

ManualsBrandsOStream ManualsElectronicsOstream-SX1280 module, low-power module for transmitting and receiving digital data via radio frequency

6.4. External Antennas

6.4.1. The SX1280_NPL_DF is pre-approved for use with the following external antennas:

Manufacturer

Part #

Type

Gain (dbi)

Linx Technologies

ANT-2.4-CW-RH-SMA

Helical Whip

-0.9

Linx Technologies

ANT-2.4-OC-LG-SMA

Dipole

4.0

6.5. FCC Requirements for Modular Approval

6.5.1. Any modifications made to the SX1280_NPL_DF’s printed circuit board or pre-approved

external antenna could void the user’s authority to operate this equipment. Other

external antennas can be used with the SX1280_NPL_DF module so long as the

antenna is of the same type and of equal or lesser gain than the authorized antennas.

6.6. Instruction to the User

6.6.1. This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential or

commercial installation. This equipment generates, uses and can radiate radio

frequency energy and if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

* Consult the dealer or an experienced radio/TV technician for help.

In order to maintain compliance with FCC regulations, shielded cables must be used with

this equipment. Operation with non-approved equipment or unshielded cables is likely to

result in interference to radio and TV reception. The user is cautioned that changes and

modifications made to the equipment without the approval of the manufacturer could void

the user's authority to operate this equipment.

6.7. Warnings

6.7.1. This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions:

6.7.1.1. This device may not cause harmful interference

6.7.1.2. This device must accept any interference received, including interference

that may cause undesirable operation

6.7.2. This device is intended for use under the following conditions:

6.7.2.1. Indoors or Outdoors

6.7.2.2. Stationary Installation

25422 Trabuco Rd. ● Ste 105-467 ● Lake Forest ● CA ● 92630