Specifications

ManualsBrandsOStream ManualsElectronicsOstream-SX1280 module, low-power module for transmitting and receiving digital data via radio frequency

OStream SX1280_NPL_DF v1.0 Documentation

Features:

● 2.40GHz-2.48GHz Operation

● +12.5dBm Output Power

● U.FL Antenna Connector for External Antenna

● LORA, GFSK and FLRC Modulation Modes

● FCC/CE Modular Approvals in Place

● Single 3.3-Volt Power Supply

1. Introduction

1.1. The Ostream-SX1280 Radio module is a low-power module for transmitting and receiving digital

data via radio frequency. All of the Ostream-SX1280 radio electronics (including an external

IPEX/UF.L antenna connector) reside on a single PCB, and all operational power is derived from

a single supply voltage with a range from 1.8v to 3.7v. The transceiver design consists of a

Semtech SX1280 low-power, integrated 2.4GHZ based transceiver supporting the following

baseband modulations: LORA, GFSK and FLRC.

2. Electrical Specifications

Supply Voltage

1.8-3.7V

Frequency Range

2.402-2.48GHz

Output Power

17mW (+12.5dbm)

TX/RX Range

6+ Miles

Protocols

LoRa, GFSK, FLRC

Communications Interface

SPI

Number of Channels Used

Operational Power - Transmit

24mA

Operational Power - Receive

4.8mA-5.6mA

Operational Power – Sleep

1uA (Deepest Sleep Mode)

Antenna Connector

u.fl

Operating Temperature

-40C to +85°C

25422 Trabuco Rd. ● Ste 105-467 ● Lake Forest ● CA ● 92630

www.ostream.com ● hello@ostream.com

Summary of content (6 pages)

PAGE 1
OStream SX1280_NPL_DF v1.0 Documentation Features: ● 2.40GHz-2.48GHz Operation ● +12.5dBm Output Power ● U.FL Antenna Connector for External Antenna ● LORA, GFSK and FLRC Modulation Modes ● FCC/CE Modular Approvals in Place ● Single 3.3-Volt Power Supply 1. 2. Introduction 1.1. The Ostream-SX1280 Radio module is a low-power module for transmitting and receiving digital data via radio frequency. All of the Ostream-SX1280 radio electronics (including an external IPEX/UF.
PAGE 2
3. 3. IO Pins 4. Images 5. 5. Mounting Options 5.1. The SX1280_NPL_DF should be surface mounted to a printed circuit board or plugged into a matching Adam Tech PH1-07-UA connector. Regulatory Agency Considerations 6.1. This device complies with Part 15.247 of the FCC Rules. 6.2. Compliance with the appropriate regulatory agencies is essential in the deployment of all transceiver devices. OStream Inc. has obtained modular approval for this RF product.
PAGE 3
6.4. External Antennas 6.4.1. The SX1280_NPL_DF is pre-approved for use with the following external antennas: Manufacturer Part # Type Gain (dbi) Linx Technologies ANT-2.4-CW-RH-SMA Helical Whip -0.9 Linx Technologies ANT-2.4-OC-LG-SMA Dipole 4.0 6.5. FCC Requirements for Modular Approval 6.5.1. Any modifications made to the SX1280_NPL_DF’s printed circuit board or pre-approved external antenna could void the user’s authority to operate this equipment.
PAGE 4
6.7.2.3. 6.7.2.4. 6.7.2.5. Temperature Range: -40 to 85 Celsius Use 1 of the approved antennas The module has been approved using the FCC’s “unlicensed modular transmitter approval” method. 6.7.3. As long as these conditions are met, further transmitter testing will not be required. However, the OEM integrator is still responsible for testing their end product for any additional compliance measures necessitated by the installation of this module (i.e.
PAGE 5
6.11.1. Testing of the host product with all the transmitters installed – referred to as the composite investigation test- is recommended, to verify that the host product meets all the applicable FCC rules. The radio spectrum is to be investigated with all the transmitters in the final host product functioning to determine that no emissions exceed the highest limit permitted for any one individual transmitter as required by Section 2.947(f).
PAGE 6
7. Disclaimer 7.1. Neither the whole nor any part of the information contained herein nor the product described in this datasheet may be adapted or reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis, and no warranty as to their suitability for any particular purpose is either made or implied. OStream Inc.