User Guide

Connect the other end of the cable to the Host card. If you have
another host card, plugin the other end of the cable to the 2nd
Host card.
One Stop Systems |
www.onestopsystems.com
Toll Free: [phone] Local: + 1(760)-745-9883
Set Host Card to Host mode x16
Install Host Card
1
2
Connect Ipass Cables To Host Card
Connect Power Cables
Power Supply and Front LEDs
7
Verify Host and Target Card Link LEDs
8
Unit is Ready
Check dipswitches are set to Host mode. Refer to User’s manual
for details on the switch setting.
Turn Off computer. Plug in the card in x16 slot. Plugin the second
host card (applicable to 4UV-10 Slot and 16 Slot units).
Connect all available power cables / cords to the power supplies.
Upon powering up the host, the expansion unit will instantly
power Up. The two power supply LEDs and the two front LEDs
will illuminate as solid green.
Verify and check that there is a stable link between Host and
Target cards. Both cards will illuminate the following LEDs:
CBL, EDG & PWR.
Connect Ipass Cables to Target Card
3
Connect the x16 Ipass cable to Target . If you have 4UV-10 or 16
slot units, plugin the second Ipass cable to the second target card.
4
5
Power UP Computer
6
Connect power cable (s) to computer. Press the power button to
power up.
9
The unit is now ready to use.
To install your PCIe card, please shutdown the expansion
unit and computer completely.
Disconnect power cables from the expansion unit.
Plug in your preferred PCIe cards in the downstream slots
and secure it.
Reconnect power cables to expansion unit.
Turn ON the computer. The expansion unit will power UP.
Please refer to the manual for more details.
x16 PCIe Slots
Front Panel LEDs