Instructions / Assembly

MET807 CHAIR W/ OTTOMAN

ASSEMBLY INSTRUCTIONS

PART (CHAIR) QTY

1A. Chair ...................1

2A. Legs ...................4

3. Screw ....................4

4. Allen Wrench (not shown) ....1

PART (OTTOMAN) QTY

1B. Ottoman ................1

2B. Dust Barrier ..............1

Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.

STEP 1 Remove Dust Barrier (2B) from Ottoman (1B), take out the four Legs (2A).

STEP 2 Place Chair (1A) face down on a soft surface, screw on all four Legs (2A) to each corner of the Chair (1A), secure Legs (2A) using one

Screw (3) for each Leg (2A). SEE DETAIL A. FULLY TIGHTEN ALL SCREWS.

STEP 2 Attach Dust Barrier (2B) to bottom of Ottoman (1B), using the Hook and Loop Material.

ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR OR OTTOMAN.

IMPORTANT NOTE:

1. Use hand tools only for assembly as power tools may cause damage

2. Carefully remove any staples used for packaging.

STEP 1

DETAIL A

STEP 3

STEP 2

Phillips Screwdriver also needed

for assembly (not provided)