Use and Care Manual

105 / 108
WOOD DESK CHAIR
ASSEMBLY INSTRUCTIONS
PART QTY
1. Base .......................1
2. Caster ......................5
3. Pneumatic Cylinder ............1
4. Bellows .....................1
5. Seat Plate ...................1
6. Wood Seat ...................1
7. Wood Back ..................1
8. Arms (8L & 8R) ...............2
9. Small Allen Screws ............4
10. Medium Allen Screws .........6
11. Long Allen Screws ...........3
12. Flat Washers ................4
13. Lock Washers ...............4
14. Wood Caps .................9
15. Allen Wrench (not shown) ......1
16. Wooden Cleat ...............1
17. Rubber Mallet (not provided) ....1
1
3
4
5
6
9,13,12
10,14
11,14
DETAIL A
7
8L
8R
10,14
2
© Office Star Products January 2013
10,14
10,14
DETAIL B
17
16
2
1
Remove all parts from carton, separate them by part numbers indicated on the parts list, and verify parts quantities.
STEP 1 Attach Wood Back (7) to Wood Seat (6) using three Long Allen Screws (11). SEE DETAIL A. FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (15).
Cover holes in Wood Back (7) using three Wood Caps (14).
STEP 2 Attach Seat Plate (5) to Wood Seat (6), with arrow pointing towards the front of the chair, using four Small Allen Screws (9), four Lock Washers (13) and four
Flat Washers (12). FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (15).
STEP 3 Aligh the holes in Arms (8L and 8R) with the holes in the Wood Back (7) and Wood Seat (6), secure Arms (8L & 8R) to Wood Seat (6) using three Medium
Allen Screws (10) for each Arm (8). FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (15). Cover holes in Arms (8L & 8R) using three Wood Caps (14)
for each Arm (8).
STEP 4 Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place. Use Wooden Cleat (16) and Rubber Mallet (17) for easy
installation. SEE DETAIL B. Place Base (1) upright so Casters (2) are on the floor, insert Pneumatic Cylinder (3) into Base (1) and slip Bellows (4) over Pneumatic
Cylinder (3), Place Assembled seat onto Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION : VERIFY THAT ALL SCREWS ARE FULLY TIGHTENDED BEFORE USING CHAIR.