November, 2018 HSB30 HILLSBORO FILE CABINET Assembly Instructions - Important: Carefully unpack and identify each component before attempting to assemble. Refer to parts list. Please take care when assembling the unit and always set the parts on a clean, soft surface. If you require any assistance with assembly, parts or information on other products, please visit our website: www.officestar.net or call or write us.
1. Do not use this product unless all screws and bolts are securely tightened. 2. Check that all screws and bolts are tight every three months or as needed. 3. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation. 4. Do not use this product as a stepladder. 5. Use this product for its intended purpose only. 6. Intended for residential use only.
PARTS (A) Drawer front Panel (2 PCS) (B) Left Drawer Side Panel (2 PCS) (C) Right Drawer Side Panel (2 PCS) (D) Rear Drawer Panel (2 PCS) (E) Bottom Drawer Panel (2 PCS) (F) Top (1 PC) (G) Front Frame (1 PC) (H) Left Frame (1 PC) (I) Right Frame (1 PC) (J) Rear Panel (1 PC)
PARTS (K) Stretcher (2 PCS) HARDWARE LIST NO DRAWING DESCRIPTION SIZE QUANTITY 1 Bolt 1/4” x 35mm 12 PCS 2 Short Screw 4 x 20mm 12 PCS 3 Long Screw 4 x 35mm 24 PCS 4 Lock Washer 1/4” 8 PCS 5 Flat Washer 5/16” x 19 8 PCS 6 Wooden Dowel 5/16” x 30mm 6 PCS 7 Knob w/ Screw 5/32” 2 SETS 8 Allen Wrench M4 1 PC Phillips Screwdriver also needed for assembly (not provided).
DRAWER INSTALLATION If you need to remove the drawer with ball bearing slides from the unit, follow the steps below to prevent any damage to the slides or the drawer. If you need to remove the drawer, please pull the drawer all the way out, then push the plastic release lever of the ball bearing slide up on one side and down on the other side, and then pull the drawer completely out. See detail #A.
STEP 1 (A) (B) (3) DO NOT FULLY TIGHTEN SCREWS (3).
STEP 3 (E) (B) (C) (A) (3) DO NOT FULLY TIGHTEN SCREWS (3). STEP 4 (D) (3) FULLY TIGHTEN ALL SCREWS (3).
STEP 5 (A) (7) FULLY TIGHTEN ALL SCREWS (7). REPEAT STEPS 1-5 FOR SECOND DRAWER.
STEP 7 (I) (4) (8) (K) (5) (1) (K) (1) (8) (G) DO NOT FULLY TIGHTEN BOLTS (1). STEP 8 (H) (K) (1) (8) (G) DO NOT FULLY TIGHTEN BOLTS (1).
STEP 9 (F) (5) (1) FULLY TIGHTEN ALL BOLTS (1). STEP 10 (2) (J) FULLY TIGHTEN ALL SCREWS (2).
STEP 11 SLIDE DRAWER INTO FILE CABINET.
