Installation & Assembly

ManualsBrandsOSP Designs Manuals3 Piece Kitchen & Dining Room SetsRegal 3 Piece Counter Height Dining Set

Assembly Instructions - Important:

Carefully unpack and identify each component before attempting to assemble. Refer to parts list. Please take care when

assembling the unit and always set the parts on a clean, soft surface. If you require any assistance with assembly, parts or

information on other products, please visit our website: www.ofﬁcestar.net or call or write us.

September, 2019

BP-REGBD

REGAL DINING SET

Summary of content (7 pages)

PAGE 1
September, 2019 BP-REGBD REGAL DINING SET Assembly Instructions - Important: Carefully unpack and identify each component before attempting to assemble. Refer to parts list. Please take care when assembling the unit and always set the parts on a clean, soft surface. If you require any assistance with assembly, parts or information on other products, please visit our website: www.officestar.net or call or write us.
PAGE 2
1. Do not use this product unless all screws and bolts are securely tightened. 2. Check that all screws and bolts are tight every three months or as needed. 3. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation. 4. Do not use this product as a stepladder. 5. Use this product for its intended purpose only. 6. FOR INDOOR RESIDENTIAL USE ONLY.
PAGE 3
PARTS (A) Table Top (1 PC) (B) Side Panel (2 PCS) (C) Back Panel (1 PC) (D) Shelf (2 PCS) (E) Bottom Panel (1 PC) (F) Right Front Leg (1 PC) (G) Left Front Leg (1 PC) (H) Right Rear Leg (1 PC) (I) Left Rear Leg (1 PC) (J) Short Stretcher (1 PC)
PAGE 4
PARTS (K) Long Stretcher (1 PC) HARDWARE LIST NO DRAWING DESCRIPTION SIZE QUANTITY 1 Screw #3.5 x 12mm 4 PCS 2 Screw #4 x 25mm 2 PCS 3 Screw #4 x 38mm 2 PCS 4 Bolt 1/4” x 25mm 12 PCS 5 Bolt 1/4” x 50mm 2 PCS 6 Bolt 1/4” x 63mm 8 PCS 7 Flat Washer 5/16” x 6/8” x 0.08” 8 PCS 8 Lock Washer 5/16” x 1/2” x 0.08” 8 PCS 9 Allen Wrench 4mm 1 PC Phillips Screwdriver also needed for assembly (not provided).
PAGE 5
STEP 1 (8) (E) (1) (4) (D) (B) (C) (B) DO NOT FULLY TIGHTEN BOLTS (4) AND SCREWS. STEP 2 (6) (9) (7) (8) (H) (G) (I) (F) (A) DO NOT FULLY TIGHTEN BOLTS (6).
PAGE 6
STEP 3 (4) (9) (G) (F) DO NOT FULLY TIGHTEN BOLTS (4). STEP 4 (K) (H) (K) (I) DO NOT FULLY TIGHTEN SCREWS (3).
PAGE 7
STEP 5 (9) (K) (5) (J) (H) (K) (C) (J) (I) TURN TO THE UPRIGHT POSITION, APPLY FIRM PRESSURE TO ALIGN & FULLY TIGHTEN SCREWS USING PHILLIPS SCREWDRIVER (NOT PROVIDED). FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (9).