Technical Specifications

OSI® QUAD® Foam
Window & Door Installation Foam
Page 2 of 4
Typical Uncured
Physical Properties:
Color:
Tan
Appearance:
Minimal expansion foam
Base:
Single component polyurethane
Odor:
Ether-like
Specific Gravity:
1.107
Flash Point:
< 0°F (-18°C)
% Solids by Weight:
70%
VOC Content:
<1.5% by weight
CARB
194 g/l
SCAQMD rule 1168
Shelf Life:
18 months from date of manufacture (unopened)
Lot Code Explanation:
DD/MM/YYYY (bottom of canister)
DD/MM/YY (on box)
DD = Day of manufacture
MM = Month of manufacture
YYYY (or YY) = Year of manufacture
Example: 28/10/2013 or 28/10/13 = October 28, 2013
Typical Application
Properties:
Application Temperature:
Product should be stored above 41°F (5°C) at least 12 hours before application.
During application, working environment and substrates should be between 14°F (-10°C) and
86°F (30°C).
Tack-Free Time:
Approx. 8 to 10 minutes*
At 68-73°F, 50% relative humidity
and 3 cm diameter bead
Cut Time:
Approx. 25-35 minutes*
Cure Time:
Approx. 24 hours*
*Time is dependent on temperature, humidity and depth of sealant applied
Typical Cured
Performance Properties:
Color:
Tan
Service Temperature:
-40°F (-40°C) to 194°F (90°C)
-40°F (-40°C) to 230°F (110°C)
Long-term exposure
Short-term exposure
Surface Burning
Characteristics:
ASTM E84
Flame Spread :
Smoke Development:
10
25
Pressure Test for
Polyurethane Foam:
AAMA 812
Pressure Build-Up:
0.0247 psi
Deflection:
0.0050 inches
Specifications:
 GreenGuard Certified for Children and Schools
 Tested in accordance with AAMA 504 Voluntary Laboratory
 Test Method to qualify Fenestration Installation Procedures
 **Conforms to ASTM E2112 Standard Practice for Installation of Exterior Windows, Doors
and Skylights, Annex A1, Type A – Low Pressure Foam Sealant
**The OSI QUAD Window & Door System uses similar practices and principle as ASTM E2112 Standard Practice for Installation of Exterior Windows, Doors and
Skylights. ASTM E2112 is intended to provide technical guidance to organizations that are developing training programs for installers of fenestration units. The
majority of fenestration units and materials used to install them are certified as meeting specified performance characteristics. The OSI QUAD Window & Door
System products have been tested in accordance with the relevant specifications required for performance under both ASTM and AAMA guidelines. The
specifications for each product are listed on each components individual technical data sheet.