Technical Specifications
OSI® QUAD® Invisible
Window, Door & Siding Sealant
Page 3 of 4
Directions:
Tools Typically Required:
Utility knife and caulking gun. For best application results, OSI recommends the use of a high quality caulking gun such as the
Albion® B12 Cartridge Gun.
Safety Precautions:
Do not use inside occupied structures. Wear gloves and wash hands after use.
Preparation:
Apply sealant between 20°F (-7°C) and 120°F (49°C). For easier extrusion of sealant at lower temperatures, the material should
be kept at room temperature 24 hours prior to use. All surfaces must be clean, dry and free of old caulk, grease, dust, ice, snow,
surface water and other contaminants. Insert cartridge into caulking gun, apply moderate pressure in order to break the Break-
A-Way Seal™ inside the nozzle. Cut the tip off the cartridge at a 45° angle to desired bead size (3/8” is recommended).
Application:
Using a caulking gun, apply sealant with steady pressure, forcing the sealant into the joint. If the depth of the joint exceeds 3/8”
(9.5 mm) the use of a backer rod is recommended.
OSI QUAD Invisible will not pop or splatter and will dispense smoothly on
extrusion from the cartridge. Tooling of the sealant is not necessary or recommended. Do not feather or smear sealant. Sealant
is paintable when fully cured. Full cure may take 7 - 14 days or longer depending on ambient conditions and volume of sealant
used. Latex paint is recommended. If using oil based/alkyd paint, a latex primer should be used first.
Clean-up:
Clean tools and uncured sealant residue immediately with mineral spirits or paint thinner. Cured sealant must be carefully cut
away with a sharp-edged tool.
Storage & Disposal:
NOT DAMAGED BY FREEZING. Store in a cool, dry place. Take unwanted product to an approved household hazardous waste
transfer facility. Hardened material may be disposed of with trash.
Label Precautions:
WARNING! FLAMMABLE. HARMFUL IF INHALED OR SWALLOWED. MAY CAUSE EYE, SKIN AND RESPIRATORY
IRRITATION.
WARNING! Contains xylene, mineral spirits and ethylbenzene. FLAMMABLE. Vapors may ignite explosively. Do not use or
store near heat, sparks or open flame. Do not smoke when using this product. Extinguish all flames and pilot lights and turn off
all sources of ignition, including stoves, heaters and electric motors during use and until all vapors are gone. Prevent build-up of
vapors by opening all windows and doors to achieve cross ventilation. Use in a well-ventilated area. Avoid breathing vapors.
Avoid contact with eyes and skin. Prolonged or repeated exposure may affect the nervous system causing dizziness, headache
or nausea. If you experience eye watering, headache or dizziness, leave the area to obtain fresh air. Do not swallow. FIRST
AID: If swallowed do not induce vomiting, call a physician or Poison Control center immediately. For eye contact flush with water
for 15 minutes, call a physician. For skin contact, wash thoroughly with soap and water. If overcome by vapors, get fresh air.
KEEP OUT OF THE REACH OF CHILDREN.
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm.
NOTICE: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain,
nervous system, liver and kidney damage or may cause cardiac arrhythmia. INTENTIONAL MISUSE BY DELIBERATELY
INHALING THE CONTENTS MAY BE HARMFUL OR FATAL. If this product is used in an OSHA regulated workplace consult
the MSDS before use.
Refer to Safety Data Sheet (SDS) for further information.
Limited Warranty:
This product is warranted to be free from defects in materials when used as directed. Henkel's sole obligation shall be, at its
option, to replace or refund the purchase price of product proven to be defective. Henkel makes no other warranty, express or
implied, including warranties of MERCHANTABILITY and FITNESS FOR A PARTICULAR PURPOSE and will not be liable for
consequential or incidental damages. This limited warranty gives you specific legal rights, which vary from state to state. Henkel
may be contacted at 1.800.624.7767 M-F 9:00 am to 4:00 pm ET for warranty assistance.
Disclaimer:
The information and recommendations contained herein are based on our research and are believed to be accurate, but no
warranty, express or implied, is made or should be inferred. Purchasers should test the products to determine acceptable quality
and suitability for their own intended use. Nothing contained herein shall be construed to imply the nonexistence of any relevant
patents or to constitute a permission, inducement or recommendation to practice any invention covered by any patent, without
authority from the owner of the patent.