User's Guide

USERS GUIDE
For Pairing With The WSA TX:
1. On the WSA RX receiver, connect the Sub Out output to the LFE/Mono input on the sub
amplifier.
2. On the WSA TX transmitter, connect an audio source to the Audio In RCA jack. For LFE/mono
signals use the L channel of the RCA jack.
3. Plug in the power supplies to the wall outlet, but wait to apply power.
4. On the WSA RX receiver, power the device by applying the 5.9V DC in.
5. Press the Pair button on the WSA RX.
6. Within 10 seconds of pressing Pair on the receiver, power on the WSA TX transmitter by
applying the 5.9V DC in. Note: During the boot up process the WSA TX searches for the WSA RX
in Pair mode and connects automatically.
7. The LED indicator light will flash while not connected. Once the LED stops flashing and turns
solid then the connection is complete.
8. If the Pairing fails, refer to the troubleshooting steps of this guide.