Owner's Manual

NERO MAX12 MANUAL
OSD Control
CONFIGURING WIRELESS CONTROL VIA OUR APP
ETHERNET/WI-FI CONNECTION
After downloading and installing the OSD Control App, open the App to start linking your
wireless device to the NERO MAX12.
NOTE: If you have a 32-bit Android phone you might not be able to find the OSD Control App in the
App Store, if so please - Download the Android App by following this link.
https://drive.google.com/file/d/1Z5sbdSP-rWpmVaPAoqIFM7uPDmPhtMPw/view?usp=sharing
ETHERNET CONNECTION - Recommended
There is an RJ-45 jack on the rear
panel of this amplifier for the
connection to Ethernet. Please use
quality Cat5E/Cat6 cable, and then
follow the connection diagram.
Connect the LAN port on the rear panel of the local Wi-Fi Router. The Ethernet connection
is mainly for Wi-Fi control via APP or other control devices.
WIFI CONNECTION - Not Recommended
Because of the high stability and ease of setup, connecting to the Ethernet via Cat5e/Cat6
cable is always recommended.
1. Reset button returns settings
to factory default
The App allows you to duplicate
the features of the NERO MAX12
Control Keypad
2. When controlling via Ethernet,
please make sure the Ethernet/RS232
switch is set at Ethernet position
NOTE:
YOUR WIRELESS DEVICE MUST BE ON THE
SAME NETWORK YOU INTEND ON USING
AFTER SETUP.
We recommend using a wired ethernet connection to the internet/LAN. The IOS or Android App
provides wireless control of the audio system from a connected tablet or smartphone. Basically, the
App duplicates the Control keypad normally located in each zone/room to control the Multi
Zone/Multi Source Receiver. The Control Keypads and corresponding IR Remote are available as an
option for those who do not have an internet connection or prefer the convenience of having the
physical keypad and IR remote for each local zone.