Use and Care Manual

1. Turn on the battery power switch, firstly pay attention to the battery volume, if low battery
please charge it in time.
2. Press the power button, the product will start with the lowest constant speed level. Press
power button each time, the speed will increase one by one level to the 5th level, press it
again, the product will stop and enters standby state.
3. Press the mode key to select different modes (each mode is set to be the combination of
varied speed), shortly press the power button, the device will return to the constant speed
massage mode.
4. In any mode, press the power button for 2 seconds, the product can be shut down directly
and enter the standby state.
5. The default working time is 10 minuted. It will enter standby state after 15 mins working.
6. Do not turn on or off the device too often. When it stops, wait at least 3 seconds to restart
it.
Operation
Charging
Operation
1. For initial use, please charge the battery over 6 hours.
2. When charging, insert the DC head of the adapter to the handle’s charging port, then plug
in the adapter to electric socket.
3. The battery can be charged at any time and under any volume. How much time the battery
needs to be charged to full state depends on current battery volume.
4. This product cannot be turned on while charging.
5. The sagety protection system of the battery is sophisticated, which can effectively
prevent over-current, overcharging, and can limit the charging when the environment is
below 0 .
6. We recommend users to always keep the battery volume above medium level. Regular charging
and maintenance is beneficial to prolong the service life of the battery.