9. Governor function ON/OFF {only HELL) Select governor function ON or OFF. % Governor function works to keep the RPM corresponding to throttle position (throttle curve) against load changes due to pitch operation or voltage changes of the power batteries. Note that higher current of the power batteries is consumed. GOVERNOR controlling OFF Select OFF normally. MODE || rpm Control ON| ON 10. Setting of advance 1g Select the advanced angle of the current to the motor or the way to advance the angle.
Install the ESC in the model using Velcro tape or double faced tape so that it may not affected by vibration or shock. Make sure both the ESC and motor receive plenty of air flow for cooling via cooling hole. Insufficient cooling by air may damage the ESC and motor. the EET NORMAL SE Switch the transmitter on and make sure ATV/AFR shows (in case of computer radio). In case of a Rutabaga transmitter, set the throttle channel “Reverse”.
INSTALLATION OF THE ESC Install the ESC in the model using Velcro tape or double faced tape so that it may not affected by vibration or shock. Make sure both the ESC and motor receive plenty of air flow for cooling via cooling hole. Insufficient cooling by air may damage the ESC and motor. NORMAL SETTING Switch the transmitter on and make sure ATV/AFR shows (in case of computer radio). In case of a Rutabaga transmitter, set the throttle channel “Reverse”.
9. Governor function ON/OFF {only HELL) Select governor function ON or OFF. % Governor function works to keep the RPM corresponding to throttle position (throttle curve) against load changes due to pitch operation or voltage changes of the power batteries. Note that higher current of the power batteries is consumed. GOVERNOR controlling OFF Select OFF normally. MODE || rpm Control ON| ON 10. Setting of advance 1g Select the advanced angle of the current to the motor or the way to advance the angle.
