Programming card quick guide

ManualsBrandsORX ManualsHobbyOrangeRx Program Box (for R620X~R1220X V3 & RR12RDTS receivers)

PROGRAMMING CARD

Barcode: 189875

SKU: 9171001376-0

Programming card works with variety of products via wireless or wired connections.

Programming Card has an integrated RF module that allows to set up many receivers wirelessly (see

table further below).

Programming card makes easier to do settings for receivers.

It is especially useful for changing settings and tuning flight stabilizers in the field.

Programming Card can be used for firmware upgrade of receivers and flight stabilizers.

Programming card can be powered from:

- USB

- 1.3X3.4MM barrel power connector (up to 16.8V DC or 4 cell LiPo )

Power consumption:

- USB- 80mA max

- External power source - 50mA max at 12.6VDC

Dimensions: 63mm x 83mm x 15mm

Weight: 67 g

Display

LCD 3”, 128x64 pixels

Controls.

Navigation slider with button

Summary of content (4 pages)

PAGE 1
PROGRAMMING CARD Barcode: 189875 SKU: 9171001376-0 Programming card works with variety of products via wireless or wired connections. Programming Card has an integrated RF module that allows to set up many receivers wirelessly (see table further below). Programming card makes easier to do settings for receivers. It is especially useful for changing settings and tuning flight stabilizers in the field. Programming Card can be used for firmware upgrade of receivers and flight stabilizers.
PAGE 2
List of receivers and stabilizers working with Programming Card: AFHDS 2A long range receiver (P274, 2019 new model) AFHDS 2A Mini (P275, 2019 new model) RTH flight stabilizer (P315, 2019 new model) All V3 and up PWM receivers (R620X…R1220X) AIO stabilizer 2 servo (P311, 2019 new model) AIO stabilizer 4 servo (P322, 2019 new model) ORX serial receiver (#189868 Orange RR12RDTS receiver) Firmware update Yes Yes Yes Yes Yes Yes Yes Wired Yes Yes Yes no no Yes no Wireless No No Yes Yes Yes Yes Yes The card
PAGE 3
Jumper port function Power jumper covers various situations of power source for target(receivers) and Programming card when target is connected via UART port of Programming card. Jumper 1-2 When pins 1-2 are shortened by jumper, VCC target line of P2 (UART connector, pin 4) is connected to VCC 5 volt regulator of the Program Card.
PAGE 4
Jumper 2-3 In this position VCC_IN power applied to the power connector of the Programming Card is directly connected to UART Pin4 of the programming Card. Be careful using this option because if you power Programming card with 18V DC the same voltage will be on the Pin 4 of the UART connector. Jumper OFF When jumper is removed, Pin 4 of UART port is not connected to any power source of programming card. .