Prog_Card_Manual_V1.0

T ELEMETRY SETTINGS .
None – No telemetry transmitted from the receiver.
Analog –analog inputs for the sensors are used
MSP – telemetry data is taken from a flight control board (Betaflight, iNav, APM etc. ) using UART
connection with Flight control and MSP protocol.
(main battery voltage, current, battery usage in mAh, acceleration, GPS coordinates and speed)
Note: In MSP mode also a transfer of control channels data from Tx to flight control is available. To use
this option you need to set the control link as MSP in your Flight control settings.
B INDING SETTINGS .
Manual bind: Press and hold bind button and power the receiver ON
Autobind menu:
In autobind settings user can set the time when the receiver enters autobind mode if no signal from