Prog_Card_Manual_V1.0

ORX S ERIAL R ECEIVER (P263).
How to bind: Press and hold bind button and power the receiver ON.
If autobind is set ON then apply power to the receiver and wait for the receiver to start binding
procedure automatically. and while Rx is in bind mode turn Programming card ON.
There will be following set of menus:
1. Output type:
Output serial protocols:
- cPPM – 9 channels, pause 300us, frame 22.5ms
- SBUS – futaba SBUS protocol, 100000,8E2, inversion UART
-ISBUS – normal UART SBUS protocol
- iBUS – flysky serial protocol
- xBUS – JR protocol
- XBUS RJ01 – JR protocol, 256kbaud
- Spek2048 – Spektrum satellite 11bit protocol