Prog_Card_Manual_V1.0

5. Channels` values output.
Program Card acts when works with devices acts as Transmitter and controls outputs of the Receiver. In
this mode you can set values on the each servo output. This is very useful for mechanical setup of planes
for example. Also, these current values will be used in Fail Safe settings if chosen “set current”. See Fail
safe settings section for details.
6. Device info.
This menu item displays an info about the receiver.
- Firmware version
- Firmware date
- Unique receiver ID
- Receiver model
Please note: The receiver after reset will still remember its bind to the transmitter. Binding to the
Programming card is temporary and doesn’t corrupt previous binding to the transmitter.
Note: A receiver keeps binding data of the transmitter it was bound even it was connected to Program
Card later. To connect the receiver back to your transmitter you just need to recycle the power and have
your transmitter turned ON as usual. No need to rebind the receiver back to the transmitter again.