Prog_Card_Manual_V1.0

R620 X -R1220 X V3 RECEIVERS
How to connect: Enter the Rx binding mode (bind plug or autobind) and while Rx is in bind mode turn
Programming card ON.
There will be following set of menus:
1. Output type:
Serial output type on the bind pin – cPPM or s.Bus
2. Telemetry type:
Telemetry type options for R620…R1220:
- None – no telemetry
- Analog Voltage, current, RPM, Temperature are collected from TM connectors of the receiver. Please
read the R620x-R1220x manual to see how to connect telemetry sensors.