Prog_Card_Manual_V1.0

The card recognizes the device, reads settings and firmware version. After this the device is ready for
configuration using Program card menus.
For wired connection (not bridge): The card enters the bridge mode automatically when it reads that
the device is in bootloader mode.
Bridge mode can also be entered by turning Program Card “USB-UART enable” option on in system
menu. System menu can be accessed by press and hold the navi slider UP while turning the card ON.
S YSTEM M ENU
To enter System menu Pull and hold the slider UP when powering the Programming Card.
System menu contains:
- Programming Card Info,
- USB-UART bridge settings
- DFU mode option for Programming Card firmware update.
- Display contrast settings
- Battery reading adjustment
.