Prog_Card_Manual_V1.0

4250 mv to 4000 mv – three bars
4000 mv to 3800 mv – two bars
3800 mv to 3600 mv – one bar
3600 mv – empty
3500 mv to 3300 mv the empty logo blinks
Controls.
Sliding navigator UP moves menu marker to left, Sliding navigator DOWN moves menu marker to the
right.
Enter submenu – click navigation dial once.
Exit from submenu – navigator dial up from the most top item of the submenu. If some settings were
changed the window prompting to change settings will appear upon exit. User can chose to save or
discard changes.
Several settings can be changed at once and then stored upon exit from submenu.
Please note that if many changes need to be stored the target device can temporary loose connection
with programming card while storing data.
C ONNECTING TO THE CARD AND PC AND TYPES OF WORK
The card can act as
- a stand-alone configurator with wireless or wired connection
RTH flight stabiliser based on iNav (P315) -wireless only
V2.1 Nuvoton (R620-R1220) -wireless only
AIO Stabilizer 2 Servo (P311) -wireless only
AIO Stabilizer 4 servo (P322) -wireless only
ORX Serial Receiver (P263) –wireless, bridge to PC
AFHDS 2A long range reciever (P274) – wired only, bridge to PC
AFHDS 2A Mini (P275) – wired only, bridge to PC
- a bridge between target and PC for configuration while configuration of the target from PC (see above)
- a bridge for targets firmware update from PC – all devices mentioned above
C ONNECTING TO THE TARGET
For wireless connection: A target device should be already in binding mode. So before turning the
Programming card ON please turn the device you want to configure in binding mode.
For wired connection (not bridge): No any actions required, the device has to be simply powered ON
and connected to the programming card via UART interface.
When Program Card is turned ON it will display logo and “Searching…”