Prog_Card_Manual_V1.0

the flight control to save.
Note: when some parameters are changed but not saved yet, the info string appears: “param chng”
telling you that parameters are changed but still not stored in flight control.
2 Page 2 of PID settings.
Beginner sens – sensitivity for Beginner mode. If sensitivity is too high the model can start oscillating.
Lower sensitivity in this case.
Advance sens – sensitivity for Advanced mode. If sensitivity is too high the model can start oscillating.
Lower sensitivity in this case.
Stick param – the parameter how far from the center a control stick needs to be to disable autolevel in
advanced mode. The value range is 0…255 from stick in middle to the extreme position. This parameter
allows to make rolls and loops in Advanced mode.