Prog_Card_Manual_V1.0

Flight modes assignment on channels
ARM – АРМ. If «--» chosen than arming can be performed by moving Rudder stick to the far left position
while throttle is at MIN.
Beginner – control channel for «Beginner» mode selection
Advanced – control channel for «Advanced» mode selection
Pass Thru – passtrough mode – dtabilizer is disabled completely, Radio sticks control servos directly,
endpoints are functional.
Note: If stab modes chosen as «--» then the mode is «PRO». There is no self leveling in this mode but
gyroscope is active. It is so called Rate Mode.
Available channels selection: "AUX1 low", "AUX1 mid", "AUX1 high", "AUX2 low", "AUX2 mid", "AUX2
high", "AUX3 low","AUX3 mid", "AUX3 high", "AUX4 low", "AUX4 mid", "AUX4 high", "always ON"
Model setup
Mdl type – type of mixing for fixed wings - "F-Wing", "Classic", "V-Tail"
Min thr – minimum throttle for ESC
Max thr – maximum throttle for ESC
Min command – minimum throttle available for the stick lowest position.
Note: all previous model settings will be reset to default after changing model type.