Prog_Card_Manual_V1.0

- set current – remember the values currently coming from the Program Card. This option is used
in conjunction with Channels Menu. In channels menu you can set desirable values for your fail
safe. After this you can go to FailSafe menu and choose “set current”. The card will ask to store
values. After confirmation the values that currently set in Channels menu will be stored as Fail
Save values.
5. Channels` values output.
-
- Program Card acts when works with devices acts as Transmitter and controls outputs of the
Receiver. In this mode you can set values on the each servo output. This is very useful for
mechanical setup of planes for example. Also, these current values will be used in Fail Safe
settings if chosen “set current”. See Fail safe settings section for details
6. Device info.
Note: A receiver keeps binding data of the transmitter it was bound even it was connected to Program
Card later. To connect the receiver back to your transmitter you just need to recycle the power and have
your transmitter turned ON as usual. No need to rebind the receiver back to the transmitter again.