Prog_Card_Manual_V1.0

already known (bound) transmitter is available. Available settings:
- Autobind OFF – Receiver never enters autobind mode. To avoid accidental binding with transmitter
nearby please use this mode when possible.
- Autobind 30 (60, 120)sec. – select timeout when receiver will enter an autobind mode. Please use this
mode carefully. In autobind mode receiver blinks red LED indicating this mode before it enters binding
MSP SETTINGS .
In this menu an UART speed can be set for MSP communication with Flight control It is recommended to
use 115200 baud unless your flight control manual recommends different.
4. FailSafe settings.
All receivers are equipped with failsafe options. After missing transmitter signal for 1 second the
receiver enters failsafe mode. The channels states can be preprogrammed to make model act the most
safe way. There are several options for reaction in Fail Safe
- no packet – no output signals on servo channels at all.
- on bind – servo channels values will be same as coming from transmitter during binding
- all 1500 – all channels except throttle are 1500us. Throttle is 1003us(min)