Users Manual
6 | iASSIST 2-Pod Version Surgical Technique
2.3 Buttons, Icon and Pod Status Bar
2.3.1 Settings Button
Click the “Settings” button located at the bottom of
the iASSIST V2 Tablet screen to modify the operative
side or enter the desired cut targets for “Tibia Slope
Target” and “Femur Flexion Target”. These settings
can be modied either before or during a surgical
procedure. Settings will remain in the system for
following surgical procedures.
2.3.2 Screenshot Button
Click the “Screenshot” button located at the bottom of
the
iASSIST V2 Tablet
screen to record a picture of the
entire computer screen. This action can be performed
at any time during the surgical procedure. All images
will be saved in the surgery report found in the “Case
Data Manager“ (Refer to section 4.2).
Note: If a problem is encountered during the
surgery, it is recommended to take a screenshot
of the screen. This could be used in the instance
when a complaint has to be led.
Figure 2.3.3
Audio and Barcode buttons
2.3.3 Audio Button
Click on the “Volume down” or the “Volume up”
buttons to adjust the volume of the Tablet.
2.3.4 Barcode Button
Click the “Barcode” button located at the bottom of
the iASSIST V2 Tablet screen if a new set of Pods have
to be connected to the Tablet. The user will then be
able to scan or manually enter the new barcode.
Figure 2.3.1
Settings and Screenshot buttons