Users Manual

4 | iASSIST 2-Pod Version Surgical Technique
Figure 2.1
iASSIST V2 Tablet Setup
3. Lift the white silicon lid located on the bottom
right side of the tablet and connect the power
supply to the Tablet port. Then connect the power
cord to the power supply and plug it into an AC
outlet.
Warning: The iASSIST V2 Tablet is:
a. not intended to be used in the sterile zone; and
b. to be connected to an AC outlet during
the entire procedure. The Tablet must not be
placed in a sterile bag as it might overheat.
4. Press the power button located at the top right
hand corner of the iASSIST V2 Tablet to turn on the
computer. The home screen will be displayed after
boot-up is completed.
Warning: Do not turn o the iASSIST V2 Tablet
without having closed the application. Once
the application or the tablet is closed, the
Pods will be permanently deactivated. Once
deactivated, the Pods cannot be restarted.
5. If necessary, see the “Connection to the Internet”
section to know how to connect the Tablet to
the Internet. It is not necessary to connect to
the Internet to do an iASSIST procedure. This
connection can be used, for example, to download
system updates.
6. A strap can be installed on the shipping case to
facilitate transport.
7. Two other buttons are located at the top left of the
iASSIST V2 Tablet. The “P2” button activates and
deactivates the Wi-Fi.
Note: The Internet connection will be
deactivated while the iASSIST application is
open.