User's Manual

OrthoSensor, Inc
1560 Sawgrass Corporate Pkwy, 4
th
Floor
Sunrise FL, 33323
www.orthosensor.com
LB-03000-001 Rev B
Dec. 2012
For further information, contact the OrthoSensor Customer Service Center by phone at 954-577-7770 or by e-mail at
customerservice@orthosensor.com or go to www.orthosensor.com.
Move LinkStation to achieve an
unobstructed line-of-sight to the KB
KB is powered off
Activate with LinkStation magnet
KB batteries are low
Discard KB and replace
KB breakage
KB loaded beyond limit
KB internal components are non-
sterile and non-medical grade. Ensure
patient safety. Discard KB and replace
Lag in reported data
Software latency
Maintain knee position until data
settles (approximately 5 seconds)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the EMC limits for the Medical Device Directive 93/42/EEC (EN
55011 Class B and EN 60601-1-2.) These limits are designed to provide reasonable protection against harmful interference in a
typical medical installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to other devices in the vicinity. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving device
- Increase the separation between the equipment.
- Consult OrthoSensor for help.
This device complies with Part 95 of the FCC rules. This device may not interfere with stations operating in the 400.150
406.000 MHz band in the Meteorological Aids, Meteorological Satellite, and Earth Exploration Satellite Services and must
accept any interference received, including interference that may cause undesired operation.
Modification of this device may void the user’s authority to operate the equipment under the FCC rules above.
Model:
Quantity:
1
Type:
Single Procedure Only. Do not resterilize
B
Sterile:
Ethylene Oxide
yQ
Device Type:
Type BF
FCC ID:
XNL-ORTHOSNSR1
XNL-ORTHOSNSR2
Operating Range:
Mode of Operation:
Power Supply:
Battery Life:
Temperature:
Operation
15˚l37°
Storage
l50°
Relative Humidity:
30% 100%, submersion
10% 50%, non-condensing
Atm Pressure:
470-1060 hPa
360-1060 hPa
Rx Only: