User's Manual

Wireless Office Keyboard And Mouse
15
status “ON”→ When you press the key, you can input the “€”.
status “OFF”→You can change the “Num Lock” status.
3. Setting Wireless Office keyboard and Program
A. Make sure the receiver cable (purple) is plugged into the PS/2
keyboard port and the other cable (green) is plugged into the PS/2
mouse port.
B. Establis h communication between the receiver and keyboard. The
bottom of the receiver has a channel switch. The bottom of the
keyboard also has a channel switch. When the receiver’ s switch
setting on CH1, then the keyboard and mouse’ s channel switch
should be setting on CH1. If the keyboard and mouse setting
different channel with receiver, then they won’ t work normally.
C. The bottom of the receiver and keyboard both has an ID setting
button. Press the ID button on the receiver first; then the receiver’ s
LED will glitter (about 0.5 second glitter one time). Then press the
ID button under the keyboard. The receiver’ s LED will stop glitter;
it means the keyboard’ s setting up is completed. NOTE: When you
replace the batteries, remember to reset again!
D. This type of wireless keyboard and mouse can work in two radio
frequency channels. You may need to switch channel, for example,
if the signal from your keyboard is conflicting with that from other
users close by. To change channel, please refer to Step B.
Setting Program:
This section describes how to use the Wireless Office Keyboard setting
program.
Once the software installation for the Power Office Keyboard is completed,
the icon is shown on the Windows

taskbar. It allows you to launch
any application and several functions of your computer by simply clicking a
single button on your KEYBOARD. Right click on the (Office Keyboard