Installation & Assembly

STEP 1:
Remove the plastic covers which pre-install in the end of side rail on the Lounge Back(2) by using Allen Wrench (D).
Insert Lounge Back (2) into Back Leg (3) as shown by two adults.
Insert 2 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Lounge Back (2) into each side
on the bottom of Back Leg (3).
Insert 2 pieces of Bolt (C) from the pre-drilled holes on the side rail of the Lounge Back (2) into each end of Back Leg (3) as shown.
Use Allen Wrench (D) to tighten all the Bolts (B&C), do not fully tighten Bolts (B&C) at this step.
STEP 2:
Bx2 Cx2 Dx1
Hardware & Tool required
3
bottom of back leg
bottom of lounge back
3
2
2
Ax2 Bx2 Dx1
Hardware & Tool required
Insert assembled Lounge Back (2) into Front Leg (1) as show by two adults.
Insert 2 pieces of Bolt (B) from the pre-drilled hole on bottom of the Lounge Back (2) into each side on the bottom of Front Leg (3).
Insert 2 pieces of Bolt (A) from the pre-drilled hole on side rail of the Lounge Back (2) into each end of Front Leg (3) as shown.
After checking the leveling for all connections, please use Allen Wrench (D) to tighten all Bolts (A&B&C) clockwise until secure.
D
B
C
D
2
1
1
2
A
D
B
D
bottom of front leg
bottom of lounge back
SUNBED
Page 2 of 3