Installation Instruction

FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON VPE04
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (H1) from the xture.
4. Place the bottom glass diuser (L1) onto the holder (J1), secure using the knurling nut (N1) and the rubber washer (O1).
5. Place the top glass diuser (D1) onto the holder (I1), secure using the knurling nuts (N1) and the rubber washers (O1).
6. Connect the transformer input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (B1) are
secured. Fixture and junction box ground wires should be connected to mounting plate using green screw provided.
After wires are connected, tuck them carefully inside the junction box.
*Requires Transformer (C1) to be recessed within the junction box!
7. Connect the transformer output wires to the xture wires. Red (+) to Red (+), Black (-) to Black (-). Make sure all wire connector
(B1) are secured.
8. Secure the mounting plate (E1) to the junction box (F1) using junction box screws (A1). The side of the mounting plate marked
“GND” must face out.
MOUNTING THE FIXTURE (Fig. 1)
9. Place the xture over the mounting plate (E1), secure using mounting screws (H1).
10. Place the fabric shade (M1) onto the holder (I1) center horizontally.
F1
B1
C1
E1
A1
I1
N1
O1
D1
M1
N1
O1
H1
J1
L1
FIG 1
Input
Output
Holder
Diuser
Shade
Diuser
Knurling
nuts
Holder
Junction
box screw
Mounting
plate
Transformer
Wire
connector
Junction box
Mounting
screw
Rubber
washer
INSTALLATION INSTRUCTION