Installation Instructions

2
INSTALLATION INSTRUCTION4
LED Outdoor
FIG. 1
Ø 4"
1
3/8"
1
3/4"
Wire Connector
Allen Wrench
Allen Screw
Junction Box Screw
Canopy
Mounting Screw
Acrylic Lampshade
(Included inside Lampshade)
Mounting Plate
Input Wires
Junction Box
A
D
C
B
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Connect the fixture wires with supply wires as shownFig. 2.BLF sure all wire connectorT(A) are secure. If your outlet box has a green
or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the mounting
plate using the green screw provided. After all wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
 Secure mounting plate to the junction box using junction box screws (B).
/05&The side of the mounting plate marked “GND” must face out.
 Place the canopy over the mounting plate and secure with mounting screws.
 Twist lock the glass into the canopy, then lock it with "llen screw (C) using "llen wench (D).
Mounting Plate Dimensions