Manualshelf

Assembly Instruction Sheet

ManualsBrandsOrren Ellis ManualsCeiling LightsRendon Single Globe LED Pendant
12
Package Contents
1of2
C
Fixture Body
x1
Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LED15W
:LutronDVELV-300PorLutronSELV-300P.
Care+Maintenance
ToolsRequired:
LightSource:
CompatibleDimmerSwitches
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
STEP 2 Attach Crossbar to Outlet Box-
A. Attach the Crossbar (A) to outlet box and secure by threading outlet
box screws (not supplied) into the mounting holes on the outlet box.
Tighten until snug.
A
Figure 2
Outlet
Box
Outlet Box Screw
(not supplied)
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 3
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 4 - Attach Ceiling Canopy to Crossbar
A. Line up the holes on the side of the ceiling canopy to the mounting
holes on the Crossbar (A). Secure them with Mounting Screws (B).
Tighten until sung.
Your fixture is now assembled and ready to use. Enjoy!
B
A
Figure 4
Ceiling Canopy
Figure 1
Ceiling
Canopy
Set Screw
Cord
Slider
Crossbar
x1
A
Mounting Screw
x2
B
G
ND
2.4mm
13 Ga13 Ga
Rope
Clamp
STEP 1 Adjust the Fixture Body Height-
A. Loosen the set screw on the rope clamp by using a screwdrivers.
B. Adjust the cord length to achieve your desired fixture height. Move
the slider on the cord until it is next to the hex nut inside of the ceiling
canopy.
C. Keep excess cord inside the ceiling canopy.
LED DRIVERLED DRIVER
Assembly Instruction Sheet
Thank you for purchasing a product.

Summary of content (2 pages)