Installation Instructions

IMPORTANT

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

e supplied by the person(s) caring for and operating the xture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning o the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light o at the light switch is not sucient to prevent electrical shock.

MOUNT CROSSBAR

If there is an existing xture remove it. Expose the

supply wires from the j-box. Mount the crossbar to

the j-box. Gently pull the wires

through the center

hole in the crossbar.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These xtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

Screwdriver

Wire Cutters

Wiring Supplies as Specied

by Electrical Code

1 x 60W/E26/A19

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

Crossbar

Mounting Hardware

Mounting Plate

Back Plate

1 x Glass Shade

CERTIFICATION: CETL DAMP

APPLICATION

Wall Fixture

Before assembling your xture, please make sure thatyou carefully

read through these instruction sheets. Consider havingyour xture

installed by a qualied licensed electrician.

PAGE 1
CERTIFICATION: CETL DAMP INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’t be built into any product.
PAGE 2
CERTIFICATION: CETL DAMP CONNECT THE WIRES Gently pull the supply wires. Connect the black supply 2 wire the black fixture wire. Secure with the supplied Wire nuts. Connect the white supply wires to the white Fixture wire. Secure with the supplied wire nuts. Either Wrap the green wire around one of the protruding screws Or connect it to the supply ground wire. Secure all wire With U.L Certified electrical tape (not supplied). Tuck all wires carefully into the J-box.
PAGE 3
CERTIFICATION: CETL DAMP 5 6 3 SECURE THE GLASS SHADE Secure the glass shade to the fixture, by aligning the holes in the sides of the glass shade with the holes in the L-bends on the back plate. Insert the supplied glass retaining Tighten down to secure the glass shade. RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW FIXTURE CAUTION Please ensure that the fitting is cool and switchedoff before replacing the bulb.