Installation & Assembly

A×4 B×4 C×4
A×4 B×4 C×4
Legs Package
+
Hardware Package
Insert 1 piece of Back Leg (2) with 2 pieces of Bolt (A), 2 pieces of Spring Washer (B), and 2 pieces
of Flat Washer (C) into the bottom of Chair Body (3) as shown.
Repeat the same steps for another Back Leg (2).
Do not fully tighten Bolts (A) for either leg.
STEP2:
D×1
D×1
insert
bolt from
this side
(1)
(1)
insert
bolt from
this side
(1)
(2)
(1)
(2)
STEP1:
Please open the Velcro on the bottom of Chair Body (3) and take the legs and hardware from package on
the bottom of Chair Body (3). There are numbers shown on legs and each corner of the bottom of Chair
body (3). Please match them correctly. Attention the label '' Insert bolt from this side'' on the legs and insert
the legs at correct side.
Insert 1 piece of Front Leg (1) with 2 pieces of Bolt (A), 2 pieces of Spring Washer (B), and 2 pieces of
Flat
Washer (C) into the bottom of Chair Body (3) as shown. Repeat the same steps for other Front Leg (1).
Do not fully tighten Bolts (A) for either leg.
CHAIR