Installation Instructions

sealant.
2 3
This product is compatible with most residential type dimmers available on the market.
The dimming performance will depend on kind of dimmer and dimmer settings.
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure
the power is off.
The purchased product is covered with a 5 year warranty in respect of any defect in
material or workmanship after purchase date.
Dimming
5 Year limited warranty
• Do not clean with abrasives.
Cleaning
Installed-Congratulations...
Enjoy the light!
Aling slots on the edge of fixture with the
Pressure Clips on the mounting bracket and
PUSH to lock fixture in place.
Turn-o ff/ disconnect power at circuit braker.
Attach connector (provided) to AC cable from
junction box: L side to Black side wire.
N side to White AC wire.
STEP 1: Remove bracket from back of fixture.STEP 2:
Attach the bracket to junction box using
2 screws (provided). Pull the AC cable with
connector trough the bracket center hole.
STEP 3: Make ground connection. Next simply „click”
the two sides of the orange wire connector
together.
STEP 4:
STEP 5: Push and feed all wires up into junction box
as you raise the fixture into place.
For wet location usage, seal/caulk the edge
of the fixture to the ceiling with waterproof
STEP 6:
Visit our website for an up to date list of compatible dimmers.
We shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use negligence, accident or
exposure to natural hazard, or excessive use over the limits specifed for the unit,
or if any unauthorized alteration or repair followed.