Installation Instructions

1
Installation Instructions for
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations through the mounting plate, then remove the mounting plate.
Drill appropriate sized holes and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture onto the mounting plate and secure it in place with the fixture screws.
Install the shade by placing it over the socket and onto the shade base. Glass shades are hand-made and may haveNOTE:
thickness variations. If the glass shade is standard thickness, add the optional spacer. Then secure it in place by screwing the
collar nut onto the socket using the shade tool.
Install the lamp by pushing the lamp pins completely into the socket holes. Refer to the label on the socket for Max Wattage
Information.
1
2
3
4
5
1.0
VS24331-L1
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
6
7
8
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
1A
JUNCTION BOX
7
8
9
10
11
ANCHOR SCREW
9
MOUNTING
PLATE
11
SHADE
SHADE TOOL
SOCKET
9
ANCHOR
10
FIXTURE
SCREW
COLLAR NUT
LAMP
SHADE BASE
SPACER (SEE NOTE
IN STEP 10)
Wall