Installation Instruction

FIG. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box
Caulking
Fig. 3 Sealing
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) and the silicon gaskets (F1) from the xture.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchors (E1).
5. Secure the mounting plate to the junction box using junction box screws (B1), fasten it to the wall using wood screws (D1).
The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the xture’s wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
7. Secure the xture to the mounting back plate using the mounting screws (C1) and the silicon gaskets (F1).
8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape (Fig. 3).
Silicone Gasket
Screw
Wood Screw
Junction Box Screw
Plastic Anchor
Wire Connector
Back Plate Dimensions
Ground Wire
F1
C1
D1
B1
E1
A1
1 3/8"
1 3/4"
INSTALLATION INSTRUCTION
LED Outdoor
4
3/8"
5 1/8"
11 13/16"
15 3/4"
17 5/16"
23
9/16"
2