Installation Instructions

PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION (Fig. 1)
3. Remove the screw nut (D1) from the xture.
4. Connect the driver input/output wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
* Requires driver to be recessed within the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure the mounting plate to the junction box using
the junction box screw (B1).
The side of the mounting plate marked “GND” must face out.
6. Secure the xture onto the mounting plate with screw nut (D1).
7. Place the mitered glass on the xture, secure the metal plate with
mounting screw (C1).
8. Put the magnetic cover on the metal plate.
FIG.1
Mounting Screw
Cover
Mitered
Glass
Screw Nut
Junction Box
Screw
Fixture
Metal Plate
Mounting Plate
Input Wires
Wire Connectors
Driver
Junction Box
C1
A1
B1
D1
Back Plate Dimensions
1 3/4”
1 3/8”
Ø4”
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
INSTALLATION INSTRUCTION
LED Wall Sconce